Written by
Lena Hartwell Appliance Care EditorPublished October 27, 2026
VERIFIED
Error codeF32
ApplianceRange
What F32 points to
Section 7 of the Dacor range Technical Manual covers the ER30D, ER36D and ER48D, and F32 appears there with two alternative explanations:
the data cable running from the relay board to the control panel is loose or defective;
the membrane is defective.
Fix for each cause
Cable: the connections get tightened, and the cable is swapped out if that is needed.
Membrane: it is replaced.
Neither job is meant for the owner. Before calling, the manual only says to rule out the obvious: confirm the main power switch is on and the control panel is not locked.
Codes that sit close to F32
F20 names the same cable problem, combined with the control panel circuit board.
F2 marks the general area of communication between panel and relay board.
F11 concerns a shorted key on the keypad membrane.
Dacor range service in San Francisco
For an ER-series Dacor range in San Francisco or elsewhere around the Bay Area that keeps showing F32, see Dacor range repair and phone (415) 687-5926. Keep the code, the range model number and any checks you have made within reach.
Model compatibility: Dacor reuses codes across series and model years, so F32 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F32 means the data cable between the relay board and control panel is loose or defective, or the membrane is defective.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Dacor appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your Dacor appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
